Maintenance oil Active can be used for the maintenance of all oiled floors. The oil gives the wood a beautiful warm glow and protects the wood against wear and scratches, which extends the life.
Maintenance oil Active can be applied both manually and mechanically. Temperature of product, room and floor should be between 15 ° C-30 ° C. Always ensure good ventilation during
application and curing.
Consumption: 40-50 m2 / l.
Make your choice content 1 or 2.5 liters.
1 Clean the floor with WOCA Intensive cleaner, 125 ml in 5 l of lukewarm water. Leave the floor throughout
dry for at least 8 hours. The floor must be completely dry.
2 Shake the vial thoroughly.
3 Apply about 1 dl oil per 4 m2 with a pad (in combination with a machine), our paint roller or a cotton cloth or use a single disc machine for large surfaces.
4 It is important that the Maintenance Oil Promotion is carefully rubbed into the wood. Keep rubbing until the wood appears saturated and the surface appears even.
5 Wipe the floor with clean, dry cotton cloths before finishing the following
treat floor surface. The floor should not look wet and no excess oil should remain on the surface after rubbing dry.
6 Continue in steps until the entire floor is finished.
7 When a single disc machine is used, the floor will be dry at 20 ° C after approx. 4 hours and may be used carefully. A manually rubbed floor can be used after 24 hours. Do not expose the floor to water during the curing time.
8 The floor must be treated with WOCA Natural Soap, which leaves a protective layer in the surface. Re-oil if necessary.
9 Clean the tool with WOCA Oil Thinner.
Auto-ignition hazard: Considering the auto-ignition hazard, sanding dust and cloths with oil
be soaked, soak with water. After use, store and dispose of in a tightly closed container.
10 Always continue to clean weekly with Eco Multi Cleaner so that no dirt adheres to the floor and therefore no damage will occur.
see technical data sheet above for more info.